Skip to content
Improve My Serve

The serve contact point: reaching full extension

On a good serve the ball is hit up and slightly in front, with the hitting arm almost straight and the body and racket forming one long line. Improve My Serve measures contact height, elbow extension and arm height at contact from one phone clip.

Analyze my serve

From one phone video we measure trophy-position knee bend, contact height, arm extension and rhythm.

Download on the App Store

Where should I make contact on the serve?

Up and slightly in front of your body, at the highest point you can reach with a fully stretched arm and racket.

  • Height: as high as a fully extended arm and racket allow; the toss should peak just above that point.
  • Arm: almost straight at contact, body stretched upward.
  • Arm angle: the hitting arm close to vertical, overhead rather than beside you.

What are the three contact numbers?

The report gives contact height against your standing height, elbow bend at contact, and how high the hitting arm is raised.

  • Contact height: full-extension contact is roughly 1.25–1.35 × standing height by our estimate; the analysis flags contact under about 1.15 ×.
  • Elbow: research on skilled servers reports the elbow bent only about 30° at ball impact; the analysis flags an elbow still bent more than about 45°.
  • Arm height: a hitting arm raised less than about 70° from the body is flagged as 'possible' only, because shoulder angles are the least reliable in 2D.

What happens when contact is too low?

  • A bent arm at contact lowers the contact point and limits angle and pace.
  • A low contact point forces a loopier trajectory and more net faults.
  • Contact beside the head instead of overhead pulls the serve to the side.

Which drills raise the contact point?

  • High-point reach: toss slightly higher and reach the racket up to a target at full extension. 3 sets × 8.
  • Toss placement: toss without hitting; the ball should peak above a fully extended racket and land just in front of your lead foot. 2 sets × 15.
  • Wall shadow serve: stand side-on near a wall and shadow serve, swinging up without touching the wall. 2 sets × 10.

How do I measure my own contact point?

  • Film one serve from the side or behind, landscape, with the racket above your head in frame and sound on.
  • Contact is found from the impact sound and wrist speed, then the three contact values are measured on that frame.
  • Upload the clip to see your contact frame and numbers; a few free analyses per day on the web.

What a single phone video can and can’t measure

The honest scope of 2D pose analysis from one camera.

WhatFrom one phone video
Joint angles in the camera plane: elbow, knee bend, trunk tiltMeasured
Contact point relative to the front hip (side-on view)Measured
Order and timing of hip, shoulder and arm movementMeasured
Serve trophy position, arm extension and contact heightMeasured
Shoulder turn and hip–shoulder separation (3D rotation)Estimate only
Racket drop: inferred from the wrist path, flagged as “possible”Estimate only
Wrist and forearm rotation (pronation)Not measured
Ball speed, spin and placementNot measured
Grip and racket-face angleNot measured

Frequently asked questions

Why does a bent arm at contact matter?
A bent arm lowers the contact point, so the ball has less room to clear the net and come down in the box.
Can it measure where my toss goes?
No. The ball is not tracked, so toss placement is not measured. A low contact height often points to a low or drifting toss; check it with the toss placement drill.
Why is arm height only 'possible'?
Shoulder angles are the least reliable joint angles from a single 2D camera, so that rule is never asserted as a definite fault.

Try it on your own swing

Upload a 10–30 second clip and get your priorities in about a minute.

Analyze my serve

Sources

The reference values on this page come from these studies. Thresholds are coaching guides, not calibrated limits.

  1. Jacquier-Bret et al. Kinematics characteristics of key point of interest during tennis serve among tennis players: a systematic review and meta-analysis. Frontiers in Sports and Active Living, 2024. — Elbow flexion at ball impact 30±16 deg
  2. Baldinger et al. Influence of the Camera Viewing Angle on OpenPose Validity in Motion Analysis. Sensors, 2025. — Shoulder elevation ~100-110 deg at impact; shoulder angles least reliable in 2D